![]() ![]() Install DJI Assistant 2, to be found here, on your PC and run it.I found it much more easy (stable) to update the aircraft via a PC (using the DJI Assistant 2 software) than via a mobile (using the DJI GO 4 app). Slow yellow flashing = Neither GPS signal nor Vision System (Ex: not enough light or uniform surface).Two green flashes = Positioning mode with Vision System (no GPS signal).Slow green flashing = Positioning mode with GPS.Solid red (= not flashing) once the aircraft is turned on, to indicate the nose of the aircraft.īack Leds (same side as the battery) are used to show status (See User Manual for details):.Ledsįront Leds (same side as the camera) are used to show the orientation. If the aircraft is switch off but not the RC, this one will start to beep after some time. The switch off the RC or the aircraft, do the same operation as to switch it on. Its two front led should keep red while the two back leds will blink quickly. Once the RC or the aircraft switched on, the amount of leds being on represents the power level (1, 2, 3 or 4). pressing+ holding it until the 4 leds are on (White leds on the RC, green leds on the aircraft). ![]() pressing the power button once and immediately after.on the battery for the aircraft (the DJI Spark)īefore switching on the RC or the aircraft, charge them by plugging the batteries on the battery loader + connecting the remote with the white USB cable on the same loader.īoth the RC and the aircraft can be switch on by:.on the top-right for the RC (the Remote Control). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |